LM1036 stereo audio tone control circuit which build based on IC LM1036. This circuit will controll bass/treble level tone, volume and balance between right channel and left channel (input 1 and 2 ). You may use this circuit for stereo applications such as car radio, TV and audio systems, mp3 player, dvd player, ipod and [...]
Zener Controlled Transistor Voltage Regulators By john The efficiency of Zener regulated power supply becomes very low when the load current is high. Under such conditions a Zener controlled transistor is always used for maintaining output voltage constant. Basically there are two types of Zener controlled transistor voltage regulators. They are Series Voltage Regulators Shunt [...]
Simple to use & low cost, yet powerful flash microcontroller programmer for the Atmel 89 series. It will Program, Read and Verify Code Data, Write Lock Bits, Erase and Blank Check. All fuse and lock bits are programmable. This programmer has intelligent onboard firmware and connects to the serial port. It can be used with [...]
This Project can be used with the three phase Induction motors. The circuit will take the full control of the motor and it will protect the motor from several faults such us over voltage and under voltage and the circuit will switch on the motor under safety conditions. The circuit was fully controlled by the [...]
These devices are designed to be used as encoder/decoder pairs in remote control applications. The MC145026 encodes nine lines of information and serially sends this information upon receipt of a transmit enable (TE) signal. The nine lines may be encoded with trinary data (low, high, or open) or binary data (low or high). The words [...]
This simple circuit can be used as an aid for sensing the distance between the rear bumper of the car and any obstacle behind the car. The distance can be understood from the combination of the LEDs (D5 to D7) glowing. At 25cm D7 will glow, at 20 cm D7&D6 will glow and at 5cm [...]
Here’s a fire alarm circuit using LDR (Light Depending Resistor) as light sensor. It warns the user against fire accidents. It relies on the smoke that is produced in the event of a fire. When this smoke passes between a LED and an LDR, the amount of light falling on the LDR decreases. This causes [...]
