bass booster circuit Bass Boost is now in good health … If you’re driving, gut-vibrating pulse of disco, or a continuous line of soft rock bottom, hard, or relaxed. One way to get the bass boost its modern without running to buy a piece of expensive capital works is to use a Bass Booster between [...]
Bass Booster Stereo Preamplifier Circuit Parts: P1_________________10K Log.Potentiometer (Dual-gang for stereo) P2________________100K Log.Potentiometer (Dual-gang for stereo) (See Notes) R1,R2_____________100K 1/4W Resistors R3,R6______________15K 1/4W Resistors R4_________________10K 1/4W Resistor R5_________________22K 1/4W Resistor R7__________________1K 1/4W Resistor R8________________560R 1/4W Resistor C1,C2,C5____________2µ2 63V Electrolytic Capacitors C3________________470µF 35V Electrolytic Capacitor C4__________________1µF 63V Polyester Capacitor C6_________________47nF 63V Polyester Capacitor C7_________________22µF 25V Electrolytic [...]
This circuit is of an 2x 2,500W RMS stereo amplifier, super-light and without switching-mode power supply. The circuit just shows a channel, and the power supply that it assists to the two channels. The audio circuit should be duplicated, but the power supply assists to the two channels without problems. A special care should be [...]
The circuit of AM transmitter is designed to transmit (amplitude modulated) DSB (double side band) signals. A modulated AM signal consists of a carrier and two symetrically spaced side bands. The two side bands have the same amplitude and carry the same information. In fact, the carrier itself coveys or carries no information. In a [...]
Micro Power AM Broadcast Transmitter In this circuit, a 74HC14 hex Schmitt trigger inverter is used as a square wave oscillator to drive a small signal transistor in a class C amplifier configuration. The oscillator frequency can be either fixed by a crystal or made adjustable (VFO) with a capacitor/resistor combination. A 100pF capacitor is [...]
This circuit consists of two identical intercom units. Each unit contains a power supply, microphone preamplifier, audio amplifier and a Push To Talk (PTT) relay circuit. Only 2 wires are required to connect the units together. Due to the low output impedance of the mic preamp, screened cable is not necessary and ordinary 2 core [...]
Mixer circuit above has 3 line inputs and 3 mic inputs. The mic inputs are suitable for low impedance 200-1000R dynamic microphones. An ECM or condenser mic can also be used, but must have bias applied via a series resistor. As with any mixer circuit, a slight loss is always introduced. The final summing amplifier [...]
