This project flashes 18 LEDs at three different rates and you can use these to create a Christmas decoration of your choice. The circuit is kept simple (and cheap!) by using the 4060B IC which is a counter and oscillator (clock) in one package. The circuit requires a 9V supply, such as a PP3 battery. [...]
0-30 VDC STABILIZED POWER SUPPLY Schematic This is a high quality power supply with a continuously variable stabilised output adjustable at any value between 0 and 30VDC. The circuit also incorporates an electronic output current limiter that effectively controls the output current from a few milliamperes (2 mA) to the maximum output of three amperes [...]
2 Way Cross-Over 3500 Hz (bass and treble) This is 2 way cross-over for your speaker system. This circuit will handle 2 speaker that are woofer (low frequency) an tweeter (high frequency). The result will shown as below picture: Here the schematic diagram of the circuit:
This simple inverter. The main aim of this circuit is to provide a suitable supply for all kind of low power battery chargers that normally connect to the mains such as mobile phones, electric shavers, etc, even an electronic neon light rated at 5W was successfully connected. Only easily obtainable components are used. http://www.circuits-lab.com/
This circuit is of an 2x 2,500W RMS stereo amplifier, super-light and without switching-mode power supply. The circuit just shows a channel, and the power supply that it assists to the two channels. The audio circuit should be duplicated, but the power supply assists to the two channels without problems. A special care should be [...]
Mixer circuit above has 3 line inputs and 3 mic inputs. The mic inputs are suitable for low impedance 200-1000R dynamic microphones. An ECM or condenser mic can also be used, but must have bias applied via a series resistor. As with any mixer circuit, a slight loss is always introduced. The final summing amplifier [...]
The original CK217 was an improvement on the CK200 FM Transmitter. This new FM Transmitter can transmit over 900 feet in the open depending on aerial used. The tank oscillator coil is built into the circuit board, and has been tinkered with to give the best distance and stability for it’s size. The battery supply [...]
